Table of Contents
Advertisement
You can set the detection level for each sampled pixel. The smaller the value, the greater the
sensitivity. To avoid triggering motion detection on small objects in the image, enter a higher
value.
After you have defined the detection (sensitivity) level of each pixel, you can set the sensitivity
level of the entire motion detection area. A setting of 80, for example, means that motion
detection is triggered when 20 percent or more of the sampled pixels change (are in motion).
The larger the sensitivity value, the greater the sensitivity of motion detection.
You can also set the time interval between each detected motion.
To set the motion detection sensitivity:
1.
2.
3.
4.
Setting the Motion Detection Actions
You can specify what actions you want the camera to perform when suspicious motion is
detected in the active motion detection window. You can select more than one action. See the
following sections for more information.
To enable alarm relay outputs:
Under Triggered Action (see
Enable alarm output 2 check boxes.
To upload images to an SD card that you have configured:
1.
2.
Figure 6-13
Motion Detection Sampling Every Three Pixels
Under Motion Detection Setting, type a value between 1 and 10 in the Sampling pixel
interval field (see
Figure
6-12).
Type a value between 1 and 100 in the Detection level field (default = 10).
Type a value between 1 and 100 in the Sensitivity level field (default = 80).
Type a value between 0 and 7200 in the Time interval(sec) field (default = 10 seconds).
Figure
Note
A Micro SDHC card must be connected to the back panel of the camera for this
function to work. See
the Micro SDHC card.
Under Triggered Action, select the Record stream to sd card check box. The record to
SD card options will appear below the check box (see
In the Pre-trigger buffer field, enter the number of seconds of video to record before the
trigger occurs (from 1 to 9999).
6-12), select one or both of the Enable alarm output 1 and
Figure 2-5
and
Table 2-3
on
Figure
Configuring Alarms | 85
page 25
for the location to install
6-8).
800-11873V2 - A - 07/2013
Advertisement
Table of Contents
