Configuring Maintenance Settings; Upgrading Firmware - Honeywell 35 Series User Manual

When the DST start time arrives, the device time automatically goes forward one

hour.
When the DST end time arrives, the device time automatically goes backward one

hour.
Device time: Device display time.
Current PC time: Time on the current PC.
Set manually: Enables you to manually set the device time.
NTP: IP address or domain name of the NTP server. Check the checkbox to enable NTP.
NTP server addr: The NTP server IP.
NTP Port: Port number of the NTP server.
Check the time interval( at least 10 s): Set time interval to check if the device time
synchronizes with the NTP server time.

Configuring Maintenance Settings

Go to Setup > System Setup > Maintenance.
This chapter describes how to restore the camera to factory default, upgrade firmware
version, etc.

Upgrading Firmware

On this page, you can upgrade the firmware of the camera. It takes a few minutes to
complete the process.
Do not power off the camera during the upgrade.
Note: •
If an SD card is used in your camera, backup your SD card contents if necessary
•
before the upgrade.
Follow the steps below to upgrade the firmware:
1. Click CHOOSE FILE and locate the firmware file.
2. Click UPGRADE. The camera starts to upgrade and will reboot automatically when
Honeywell 35 Series IP Cameras User Guide
53