Table of Contents
Advertisement
To enable/disable on-screen display:
1.
2.
3.
Set Pan Zero
Click Set to set the pan setting to zero at the current PTZ camera position. Setting pan to zero
will set the current PTZ camera position as North. This setting will affect the direction information
that is displayed on the OSD (see
TV System
Depending on the location that you are using the HDZ Series 1080p IP PTZ camera, you may
need to switch the TV System settings between PAL/NTCS. Generally, systems in North America
use NTSC and systems in Europe use PAL. If this unit was purchased in a PAL region, the
camera should be set to PAL by default. If this unit was purchased in an NTSC region, the
camera should be set to NTSC by default. Check with the system administrator if you are unsure
what setting to use at your location.
To switch the TV system setting:
1.
2.
3.
Restore Defaults
You can undo any changes that you have made to the camera settings and restore the camera
to its factory default settings. See also
To restore the camera default settings:
1.
2.
Navigate to PTZ
Camera.
Under Misc (see
Figure
5-12), in the OSD drop-down list, select one of the following:
•
On to enable the on-screen display.
•
Off (default) to disable the on-screen display.
Click Set to save the setting.
Navigate to PTZ
Camera.
Under Misc (see
Figure
5-12), in the TV System drop-down list, select one of the
following:
•
30 fps(NTSC) to use the North American TV system setting. This is the default setting
if the camera is the NTSC model.
•
25 fps(PAL) to use the European TV system setting. This is the default setting if the
camera is the PAL model.
Click Set to save the setting.
Navigate to PTZ
Camera.
Under Default, click Set default (see
On Screen Display on page 72
Restoring Factory Defaults on page
Figure
5-12).
Configuring PTZ Settings | 73
for more information).
111.
800-11873V2 - A - 07/2013
Advertisement
Table of Contents
