Linecardmgmtprotocol Messages; Logging Redirect Messages - Cisco Catalyst 4500 Series System Message Manual

Chapter 2 Messages and Recovery Procedures

LINECARDMGMTPROTOCOL Messages

This section contains the module management protocol (LINECARDMGMTPROTOCOL) messages.
Error Message C4K_LINECARDMGMTPROTOCOL-3-FAILEDTOSEND: EsmpDriver [char] - Failed to
send ESMP requests due to [char].
Error Message C4K_LINECARDMGMTPROTOCOL-4-INITIALTIMEOUTWARNING:
[char] - management request timed out.
Error Message C4K_LINECARDMGMTPROTOCOL-4-ONGOINGTIMEOUTWARNING:
[char] - consecutive management requests timed out.

LOGGING REDIRECT Messages

This section contains the Logging Redirect ISSU messages.
Error Message LOGGING_REDIRECT_ISSU-2-GET_BUFFER: Logging Redirect ISSU client
failed to get buffer for message.
OL-13091-01
This message indicates a failure in ESMP request generation for the reason given. This
Explanation
is probably due to high CPU utilization caused by a number of factors, and under these
circumstances switching module communication protocol packets can not be transmitted.
If you see this message frequently, analyze the traffic going to the CPU and
Recommended Action
contact your technical support representative to debug the problem.
There are communication problems with the module ASIC that fans out a single gigabit
Explanation
port to front-panel ports. A few messages are within tolerance levels.
This is an informational message only. No action is required. If this message is
Recommended Action
seen frequently, refer to: http://www.cisco.com/en/US/products/hw/switches/ps663/
products_tech_note09186a00801c9221.shtml
There are persistent communication problems with the module ASIC that fans out a
Explanation
single gigabit port to front-panel ports.
Reinsert the module.
Recommended Action
The Logging Redirect ISSU client failed to get buffer space for building a negotiation
Explanation
message. A negotiation message cannot be sent to the standby device. If a problem occurs with the
ISSU session negotiation, the standby device cannot be brought up properly.
Copy the error message exactly as it appears on the console or in the system
Recommended Action
log. Issue the show logging and show checkpoint client commands to gather data that may help
identify the nature of the error. Research and attempt to resolve the error using the Output Interpreter
at https://www.cisco.com/cgi-bin/Support/OutputInterpreter/home.pl. Issue the show tech-support
command to gather data that may helpidentify the nature of the error. Also perform a search of the
Error: [dec] ([char])
Catalyst 4500 Series Switch Cisco IOS System Message Guide
LINECARDMGMTPROTOCOL Messages
2-71