Pktprocessing-3 - Cisco Catalyst 4500 Series System Message Manual

PKTPROCESSING Messages
Error Message C4K_PKTPROCESSING-3-REPLICATEDINVALIDVLAN: Replicated packet received
on Vlan 0, CRC32 is valid. PortId [dec] [l2-header] Vlan [dec] TagType
[object-info] count [object-info]
Error Message C4K_PKTPROCESSING-3-UNEXPECTEDOUTPUTACLHIT:Packet hit output ACL but
sent to CPU as a result of hardware input Acl processing [l2-header] Port char]
Vlan [dec]
Error Message C4K_PKTPROCESSING-3-UNRECOGNIZEDEVENT:Packet received for an
unimplemented event. CPU Subport [dec] TxQId [dec] PDD {[dec], [dec]}
PKTPROCESSING-4
Error Message C4K_PKTPROCESSING-4-ERRORPACKET:[char]
Error Message C4K_PKTPROCESSING-4-UNKNOWNBRIDGEORROUTEREPLICATED: Unable to
determine whether to route or bridge replicated software-processed packet with
source
destination IP
Catalyst 4500 Series Switch Cisco IOS System Message Guide
2-76
Explanation A replicated packet was received on VLAN 0. The CRC32 packet is correct. If the count
is high, there may be a hardware problem.
Recommended Action Contact your technical support representative.
A n inconsistent hardware state might exist. A packet was sent to the CPU due to input
Explanation
ACL processing by the hardware. The packet unexpectedly encountered output ACL processing.
Contact your technical support representative.
Recommended Action
The hardware sent a packet to the CPU, but the software did not recognize the event that
Explanation
triggered the packet to be sent.
This is an informational message only. No action is required.
Recommended Action
Explanation The software is unable to process a packet; the packets have been forwarded to the CPU
instead and the packet will be dropped.
Recommended Action This is an informational message only. No action is required.
mac [mac-addr]
[ip-addr]
When a replicated packet is sent to the software by an output ACL, the hardware does
Explanation
not indicate whether the packet needs to be bridged or routed.
When resources are exhausted or when the ACLs that are programmed in the hardware cannot
handle processing directly (such as ACLs matching TCP flags), the supervisor engine sends the
packets to the software for processing. If the software cannot determine whether to bridge or route,
the packet might be dropped. This drop indicates that the packet was directed to a Hot Standby
Routing Protocol (HSRP) router group MAC address.
This is an informational message only. No action is required.
Recommended Action
, destination mac [mac-addr]
Chapter 2 Messages and Recovery Procedures
, source IP [ip-addr] ,
OL-13091-01