Cisco Catalyst 4500 Series System Message Manual page 44

DOT1X (802.1X) Messages
Error Message DOT1X-5-ERR_PVLAN_TRUNK:Dot1x can not be enabled on private VLAN trunk
ports.
Explanation
Recommended Action
Error Message DOT1X-5-ERR_RADIUSVLAN_EQ_VVLAN: RADIUS attempted to assign a VLAN to
Dot1x port [char] whose Voice VLAN is same as Access Vlan
Explanation
voice VLAN settings are identical to the access VLAN settings.
Recommended Action
identical to the voice VLAN settings for this interface.
Error Message DOT1X-5-ERR_RSPAN_VLAN:Dot1x can not be enabled on ports configured in
Remote SPAN vlan.
Explanation
trying to set 802.1X port control to auto or force-unauthorized (force_unauth) mode on a port that
is in the remote SPAN VLAN, which is not allowed.
Recommended Action
Error Message DOT1X-5-ERR_SPANDST: Dot1x can not be enabled on [char]. It is
configured as a SPAN Dest port.
Explanation
destination ports are mutually exclusive features.
Recommended Action
port.
Error Message DOT1X-5-ERR_TRUNK: Dot1x can not be enabled on Trunk port
Explanation
mode (or disable state with force-authorized mode).
Recommended Action
Error Message DOT1X-5-ERR_TUNNEL:Dot1x can not be enabled on 802.1q tunnelling
enabled ports
Explanation
by trying to set 802.1X port control to auto or force-unauthorized (force_unauth) mode on a
802.1Q tunnel-enabled port, which is not allowed.
Recommended Action
Catalyst 4500 Series Switch Cisco IOS System Message Guide
2-26
802.1X cannot coexist with private VLAN trunking on the same port.
This is an informational message only. No action is required.
The RADIUS server attempted to assign a VLAN to a supplicant on an interface whose
Update the RADIUS configuration so that the access VLAN settings are not
802.1X cannot be enabled on the remote SPAN VLAN port. This condition is caused by
Disable remove span on the VLAN, and then enable 802.1X.
The switch was not able to configure Dot1x on a given port because Dot1x and SPAN
Disable the SPAN destination port configuration the reconfigure Dot1x on the
Because this port is a trunk port dot1x port-control cannot enter enable state with auto
Disable trunking on the interface, and then enable 802.1X.
802.1X cannot be enabled on the dot1q tunneling-enabled port. This condition is caused
Disable 802.1Q tunneling on the interface, and then enable 802.1X.
Chapter 2 Messages and Recovery Procedures
OL-13091-01