Cisco Catalyst 4500 Series System Message Manual page 101

Chapter 2 Messages and Recovery Procedures
Error Message PM-4-PORT_BOUNCED: Port [char] was bounced by [char].
Explanation
during a switchover. A port is only reactivated when the port data structures lack consistency
between the active and standby supervisor engines. The reactivation event returned the active ports
in the link-down state to the link-up state.
Recommended Action
Error Message PM-4-PORT_CONSISTENT:Port [char] consistency has been restored
Explanation
became consistent again.
Recommended Action
Error Message PM-4-PORT_INCONSISTENT: Port [char] is inconsistent: IDB state [char]
(set %TE ago)
Explanation
inconsistent for more that one second. Inconsistent ports are reactivated on switchover (you will see
the PORT_BOUNCED message).
Recommended Action
Error Message PM-4-PVLAN_TYPE_CFG_ERR: Failed to set VLAN [dec] to a [char] VLAN
Explanation
Recommended Action
might provide information about the error. If you cannot determine the cause of the error from the
error message or from the show tech-support command display, copy the error message exactly as
it appears on the console or in the system log, contact your technical support representative, and
provide the representative with the gathered information.
Error Message PM-4-TOO_MANY_APP:application '[char]' exceeded registration limit
Explanation
Recommended Action
Error Message PM-4-UNKNOWN_HOST_ACCESS: Invalid Host access value ([dec]) is
received
Explanation
Recommended Action
OL-13091-01
The Port Manager needed to perform a reactivation of a port in the link-down state
This is an informational message only. No action is required.
The port manager on the standby supervisor engine discovered that the port state
This is an informational message only. No action is required.
The port manager on the standby supervisor engine discovered that the port state was
This is an informational message only. No action is required.
The platform failed to set the private VLAN type.
Enter the show tech-support privileged EXEC command to gather data that
The Port Manager detected an invalid request. [char] in the application.
Reconfigure the host access entry using the correct type.
A n invalid host access value was sent to the host access table.
Reconfigure the host access entry using the correct type.
Catalyst 4500 Series Switch Cisco IOS System Message Guide
PM Messages
2-83