Cisco Catalyst 4500 Series System Message Manual page 87

Chapter 2 Messages and Recovery Procedures
Error Message C4K_L3HWFORWARDING-3-PBRNOPBRCAMLEFT: K2FibPbr: attempted addition of
[dec] blocks to PBR cam region failed, only managed to get
Error Message C4K_L3HWFORWARDING-3-PBRPUNTINGPORT: Policy routing exceeded maximum
TCAM usage, all IP unicast
software.
Error Message C4K_L3HWFORWARDING-3-WCCPMALLOCFAILURE: WCCP service group
could not be setup
L3HWFORWARDING-4
Error Message C4K_L3HWFORWARDING-4-FLOWCACHEOUTOFSPACEFORFLOWCACHEENTRY:
K2FibFlowCache: insufficient space to store flow of type [object-info] with label
[packet-info]
OL-13091-01
There is insufficient memory to program a new route map.
Explanation
Recommended Action Remove unused portions of the configuration to free the needed memory.
The hardware policy-based routing forwarding engine has insufficient resources to
Explanation
handle the route map for the specified interface. All unicast IP traffic for that interface will be
switched in the software instead.
This is an informational message only. No action is required.
Recommended Action
for redirection due to memory allocation failure.
The service group cannot be setup for redirection in hardware because of failure to
Explanation
allocate memory. The traffic that is expected to be redirected by this service group will be routed
normally. This condition might occur under extreme ACL, QoS, PBR, VRF, or other L2/L3 feature
configurations.
Try removing the unused or unneeded configuration on the switch before
Recommended Action
attempting to configure the service group again. Please note that even though the service group
configuration shows up in the CLI, it has failed to be set up in hardware. Therefore, the service group
should be unconfigured before configuring it again. If the above does not help, please contact Cisco
Technical Assistance for further troubleshooting and resolution of the problem.
Explanation The software cannot load a flow cache entry into the hardware due to insufficient
memory.
This is an informational message only. No action is required.
Recommended Action
traffic on interface
Catalyst 4500 Series Switch Cisco IOS System Message Guide
L3HWFORWARDING Messages
[dec] for FRM
[char] will be switched in
[char]
[char]
2-69