Portfanoutasic8X100Man-4; Qos Messages; Redundancy Messages - Cisco Catalyst 4500 Series System Message Manual

Chapter 2 Messages and Recovery Procedures
PORTFANOUTASIC8X100MAN-7
Error Message C4K_PORTFANOUTASIC8X100MAN-7-LOSTPACKET:[char] port [dec] lost a
packet

QOS Messages

This section contains the quality of service (QOS) message.
Error Message C4K_QOS-4-OUTOFPOLICERRESOURCES:Out of memory to allocate a policer

REDUNDANCY Messages

This section contains the supervisor engine redundancy (REDUNDANCY) messages.
REDUNDANCY-1
Error Message C4K_REDUNDANCY-1-VTP_CONFIG_DISLOCATE: VTP config file must be in
default location for the system
OL-13091-01
A loopback packet was lost during online diagnostics of this port.
Explanation
This is an informational message only. No action is required.
Recommended Action
The software failed to allocate memory for a policer while processing the QoS
Explanation
configuration, possibly because the policer configuration exceeded its maximum supported limit.
Remove policers from other unwanted policies, and retry the operation. Resend
Recommended Action
the command when other Telnet sessions are not sending debugging commands.
The system failed to reach SSO mode because the VTP configuration file is not i n the
Explanation
default location. In a catalyst 4500 switch, the default VTP configuration file is
cat4000_flash:vlan.dat.
Reset the standby supervisor and remove the VTP filename configuration by
Recommended Action
using the no vtp file command.
to work in SSO mode
Catalyst 4500 Series Switch Cisco IOS System Message Guide
QOS Messages
2-87