Pm-2 - Cisco Catalyst 4500 Series System Message Manual

Chapter 2 Messages and Recovery Procedures
Error Message PM-2-NOMEM:Not enough memory available for [char]
Error Message PM-2-VLAN_ADD:Failed to add VLAN [dec] - [char].
PM-3
Error Message PM-3-ERR_INCOMP_PORT: [dec]/[dec] is set to inactive because
[dec]/[dec] is a [char] port
Error Message PM-3-INTERNALERROR:Port Manager Internal Software Error
([char]:[char]:[dec]:[char])
PM-4
Error Message PM-4-BAD_APP_ID:an invalid application id [dec] was detected
Error Message PM-4-BAD_APP_REQ:an invalid [char] request by the '[char]' application
was detected
OL-13091-01
The Port Manager subsystem cannot obtain sufficient memory for the specified PM
Explanation
operation. [char] is the PM operation ID.
The VLAN was not added to VTP, because of the reason stated in the text string.
Explanation
This is an informational message only. No action is required.
Recommended Action
The private host port cannot be configured with the trunk, private, promiscuous, and
Explanation
SPAN destination port on the same coil.
Try to configure the incompatible ports on different coils.
Recommended Action
Explanation The access VLAN on the VMPS server is set to the same VLAN as a voice VLAN on
the port. The access VLAN assignment on the VMPS server should be different from the voice
VLAN.
Reset the VLAN assignments to remove the conflict.
Recommended Action
Explanation The Port Manager detected a request with an invalid application ID, where [dec] is the
application ID.
Recommended Action Reset the VLAN assignments to remove the conflict.
The Port Manager detected an invalid request. The first [char] is the invalid request, and
Explanation
the second [char] is the application making the request.
Reset the VLAN assignments to remove the conflict.
Recommended Action
Catalyst 4500 Series Switch Cisco IOS System Message Guide
PM Messages
2-79