L3Hwforwarding Messages - Cisco Catalyst 4500 Series System Message Manual

Chapter 2 Messages and Recovery Procedures

L3HWFORWARDING Messages

This section contains the Layer 3 hardware forwarding (L3HWFORWARDING) messages.
L3HWFORWADING-2
Error Message C4K_L3HWFORWARDING-2-FWDCAMFULL:L3 routing table is full. Switching to
software forwarding.
L3HWFORWARDING-3
Error Message C4K_L3HWFORWARDING-3-FTECONSISTENCYCHECKFAILED: FwdTableEntry
Consistency Check Failed: index
Error Message C4K_L3HWFORWARDING-3-FWDCAMCONSISTENCYCHECKFAILED: FwdCam Consistency
Check Failed: index
Error Message C4K_L3HWFORWARDING-3-FWDMEMPARITYERROR: Parity error in Forwarding
Memory
OL-13091-01
Explanation The hardware routing table is full; forwarding takes place in the software instead. The
switch performance might be degraded.
Reduce the size of the routing table. Enter the ip cef command to return to
Recommended Action
hardware forwarding.
There was a consistency check failure. If this error occurs frequently, it could indicate
Explanation
faulty hardware.
If the problem persists, contact your technical support representative.
Recommended Action
[dec]
There is a FwdCam consistency check failure. If this error occurs frequently, it could
Explanation
indicate faulty hardware.
If the problem persists, contact your technical support representative.
Recommended Action
There is a parity error in forwarding memory. This error message could indicate a
Explanation
transient hardware problem or a more permanent problem.
Recommended Action If you see this message multiple times, reboot the switch.
[dec]
Catalyst 4500 Series Switch Cisco IOS System Message Guide
L3HWFORWARDING Messages
2-67