Cisco Catalyst 4500 Series System Message Manual page 26

CHASSIS Messages
Error Message C4K_CHASSIS-3-MODULEBRINGUPTIMEDOUT: Module [dec] software bring up
did not complete within allocated time
Explanation
status will be shown as faulty.
Recommended Action
check if the problem occurs again. If it does, please contact Cisco technical support to get further
assistance.
Error Message C4K_SUPERVISOR-3-MUXMAYMISALIGN: Linecard Mux-buffers may mis-align to
incorrect supervisor due to reset with other supervisor desires to be active
Explanation
engine is trying to become active using hardware hot-standby logic. This may cause incorrect
alignment of the switching module mux-buffers to use the non-active supervisor engine, and the
switch will not be able to pass traffic until the alignment is reset.
Recommended Action
command, and contact your technical support representative to report the failure.
Error Message C4K_CHASSIS-3-LINECARDNOTVALIDINSLOT: Linecard [char] is not supported
in slot [dec], try slots [char].
Explanation
in this slot due to the insufficient number of backplane ports in this slot.
Recommended Action
the message.
Error Message C4K_CHASSIS-3-LINECARDSEEPROMREADFAILED:Failed to read module [dec]'s
serial eeprom, try reinserting module
Explanation
not boot because the EEPROM failed to identify the module type. The read might fail if the module
is not seated correctly in the slot.
Recommended Action
If the problem persists, contact your technical support representative. You will likely have to return
the module to Cisco to reprogram or replace the serial EEPROM.
Error Message C4K_CHASSIS-3-LINECARDSEEPROMWRITEFAILED:Failed to write module
[dec]'s serial eeprom
Explanation
seated correctly in the slot.
Recommended Action
If the problem persists, contact your technical support representative. You will likely have to return
the module to Cisco to reprogram or replace the serial EEPROM.
Catalyst 4500 Series Switch Cisco IOS System Message Guide
2-8
The module bring up could not be completed within pre-allocated time. The module
Please try using hw-mod module <module number> reset command and
While resetting the switching modules and taking them out of reset the other supervisor
Reset the other supervisor engine using the redundancy reload peer
The supervisor engine identified the type, but the switching module cannot be supported
Remove the module from the slot and place it in the alternative slot listed in
The switch cannot read the serial EEPROM of the specified module, and the module will
Remove and reinsert the module. If this message reappears, reboot the switch.
A write operation to the serial EEPROM failed. The write might fail if the module is not
Remove and reinsert the module. If this message reappears, reboot the switch.
Chapter 2 Messages and Recovery Procedures
OL-13091-01