Switchingengineman Messages - Cisco Catalyst 4500 Series System Message Manual

SWITCHINGENGINEMAN Messages

Error Message SW_VLAN-6-VTP_MODE_CHANGE: VLAN manager changing device mode from
[char] to [char].
SWITCHINGENGINEMAN Messages
This section contains the switching engine management (SWITCHINGENGINEMAN) messages.
SWITCHINGENGINEMAN-2
Error Message C4K_SWITCHINGENGINEMAN-2-PACKETMEMORYERROR3: Persistent Errors in
Packet Memory [dec]
SWITCHINGENGINEMAN-3
Error Message C4K_SWITCHINGENGINEMAN-3-BADDELIMITER:Recived CPU packet with bad
delimiter
Error Message C4K_SWITCHINGENGINEMAN-3-BADLENGTH:Recived CPU packet with bad length
Catalyst 4500 Series Switch Cisco IOS System Message Guide
2-116
Some switch devices must automatically change VTP device modes upon receipt of a
Explanation
VLAN configuration database containing more than a set number of VLANs, depending on the
device. Such a spontaneous conversion occurred, what the previous mode was, and what the current
mode is.
This is an informational message only. No action is required.
Recommended Action
Explanation There is a high rate of persistent errors in packet memory. This condition might indicate
a persistent hardware problem.
If this message persists, use the show platform commands to show results,
Recommended Action
contact your technical support representative, and provide the representative with the gathered
information.
Explanation The software expected a delimiter pattern of successive packets but received some other
pattern. This condition might be due to a loss of synchronization between the hardware and the
software.
Recommended Action This is an informational message only. No action is required.
Explanation The switch received a CPU packet that was either too long or too short.
This is an informational message only. No action is required.
Recommended Action
Chapter 2 Messages and Recovery Procedures
OL-13091-01