Linecardmgmtprotocol Messages - Cisco Catalyst 4500 Series Message Manual

LINECARDMGMTPROTOCOL Messages

LINECARDMGMTPROTOCOL Messages
This section contains the module management protocol (LINECARDMGMTPROTOCOL) messages.
Error Message C4K_LINECARDMGMTPROTOCOL-3-FAILEDTOSEND: EsmpDriver [char] - Failed to
send ESMP requests due to [char].
Error Message C4K_LINECARDMGMTPROTOCOL-4-INITIALTIMEOUTWARNING:
[char] - management request timed out.
Error Message C4K_LINECARDMGMTPROTOCOL-4-ONGOINGTIMEOUTWARNING:
[char] - consecutive management requests timed out.
LINECARDMGMTPROTOCOL Messages
This section contains the LAN Port IP (LPIP) dynamic host policies (
Error Message C4K_LPIPMAN-4-OUTOFMEMORY: Memory for constructing ACLs is not
available.
Catalyst 4500 Series Switch Cisco IOS System Message Guide Release 12.2(31)SGA
2-68
This message indicates a failure in ESMP request generation for the reason given. This
Explanation
is probably due to high CPU utilization caused by a number of factors, and under these
circumstances switching module communication protocol packets can not be transmitted.
If you see this message frequently, analyze the traffic going to the CPU and
Recommended Action
contact your technical support representative to debug the problem.
There are communication problems with the module ASIC that fans out a single gigabit
Explanation
port to front-panel ports. A few messages are within tolerance levels.
This is an informational message only. No action is required.
Recommended Action
There are persistent communication problems with the module ASIC that fans out a
Explanation
single gigabit port to front-panel ports.
Recommended Action Reinsert the module.
System memory is not available to set up LPIP dynamic host policies. LPIP host policies
Explanation
do not work if this log message appears.
To correct this problem either free some memory on the switch or upgrade the
Recommended Action
switch with additional RAM.
Chapter 2 Messages and Recovery Procedures
) messages.
LPIPMAN
OL-11541-01