Iossys-4; Iossys-7; Iossysman Messages - Cisco Catalyst 4500 Series System Message Manual

IOSSYSMAN Messages

IOSSYSMAN Messages
This section contains the Catalyst 4500 series Cisco IOS System Manager (IOSSYSMAN) messages.
IOSSYSMAN-0
Error Message C4K_IOSSYSMAN-0-FATALERRORCRASH:Forced crash due to: [char]
IOSSYSMAN-3
Error Message C4K_IOSSYSMAN-3-ENVVARNAMETOOLONG:Name of environment variable
Error Message C4K_IOSSYSMAN-3-OUTOFPACKETHEADERS:Cannot allocate buffer for a packet
header
IOSSYSMAN-4
Error Message C4K_IOSSYSMAN-4-ENVVARTOOLONG: Value of env. variable [char] is too
long
Catalyst 4500 Series Switch Cisco IOS System Message Guide
2-62
The system is unusable due to software or hardware failures.
Explanation
Analyze the memory dump, if any, and determine the cause of the failure, or
Recommended Action
contact your technical support representative.
The environment variable name is too long.
Explanation
Enter the unset command to shorten the name.
Recommended Action
The system cannot allocate a buffer for the packet header.
Explanation
Contact your technical support representative, and provide the configuration
Recommended Action
information for the switch.
The software writes certain configuration values to the NVRAM. The variable name is
Explanation
too long (greater than 4096 bytes) for the available storage space.
Boot the system into ROMMON mode. At the ROMMON prompt, enter the
Recommended Action
unset command to change the environment variable name to a shorter name.
Chapter 2 Messages and Recovery Procedures
OL-13091-01