Printer Maintenance
The Printer Maintenance tab contains the System Settings, Date & Time,
Paper Density, Adjust BTR, Adjust Fuser, Registration Adjustment, Adjust
Altitude, Reset Defaults, Non-Dell Toner, BTR Refresh Mode, Web Link
Customization, TCP/IP Settings, Tray Settings, EWS, Scan Defaults, Fax
Defaults, Copy Defaults, and Fax Settings pages.
NOTE:
Values marked by an asterisk (*) are the factory default menu settings.
System Settings
Purpose:
To configure the power saving mode, auto clear time, warning tones, time-out
time, operator panel language settings, job log auto print, and mm/inch
setting.
Values:
Power Saver
Sleep
Timer
Deep Sleep
Auto Reset
45 seconds*
1 minute
2 minutes
3 minutes
4 minutes
Alert Tone
Panel Select
Tone
*1
5 minutes*
5– 30 minutes
6 minutes*
1–6 minutes
Specifies the time taken by the printer before it
automatically resets the settings for Copy, Scan, or Fax
on the operator panel to the defaults when no
additional settings are made.
Off*
Low
Medium
High
Specifies the time taken by
the printer before it enters
Sleep mode after it finishes
a job.
Specifies the time taken by
the printer before it enters
Deep Sleep mode after it
goes into Sleep mode.
Does not emit a tone when the operator
panel input is correct.
Emits a tone at the specified volume
when the operator panel input is correct.
Understanding the Tool Box Menus
333