Toshiba Perfecptione Installation And Maintenance Manual page 254

PROGRAMMING PROCEDURES
SECTION 200-255-318
FEBRUARY 1992
CHAPTER 18
VERIFIABLE ACCOUNT CODES DATA
1. Verifiable Account Codes Data Block (Table
18-I)
1.01 If a station user is required (via the COS) to
enter verifiable account codes, the Verifiable Ac-
count Codes Data Block
(DVAC Program)
en-
ables the system to verify the account codes en-
tered. The account code can be a 1 - - 12-digit code,
and it is output via the SMDR port as part of the
SMDR data.
NOTE:
DMDR's ACL MUST be programmed before
the Verifiable Account Codes in the DVAC
program will be operable.
Data for this program is entered as follows:
REQ (Request)-Indicates that the program has
loaded. CHG is the only possible response.
TYPE (Data
Type)-Indicates the addition or de-
letion of verified account codes.
Enter: ACTA (to add codes), or ACTD (to de-
lete codes).
ACL (Account Code
Length)-Defines the length
of the account code that is to be used, or indi-
cates that no account code is to-be used. (The
ACL prompt appears only if TYPE = ACTA.)
NOTES:
1. The Account Code Length (ACL) is de-
fined in the DMDR (Station Message De-
tail Recording) Program.
2. No entry to the ACL prompt is possible
here. The system will print out the infor-
mation from the ACL prompt in the DMDR
Program.
A (Account Codes to
Add)-Defines the account
codes. (The A prompt appears only if TYPE =
ACTA.)
Enter: I- - 12-digit
Account Codes (spaces
between them) depending on digit length,
as defined in the ACL of DMDR.
NOTE:
For ease of entry, Account Codes will auto-
matically be distributed to the appropriate
tables.
TABLE NO.
(Table
Number)-Indicates the table
number that the account codes are to be deleted
from. (The TABLE NO. prompt appears only if
TYPE = ACTD.)
Enter: 0 - 14.
ACT-(TABLE
#) (Account
Number)-The
Table Number (from the Table Number indicated
in TABLE NO. entry) of the account code that is
to be deleted (see Table 18-la).
NOTE:
No entry to the ACTprompt is necessary. The
system will print out the account codes from
the entry at the TABLE NO. prompt.
D (Account Codes to
Delete)-Defines the ac-
count codes (the D prompt appears only if TYPE
= ACTD).
Enter: The number associated with each ac-
count code to be deleted.
18-1