Table of Contents
Advertisement
CHAPTER 4
SYSTEM INSTALLATION
1. PERCEPTION,
1 .OO
Power Supply installation
1 .Ol Install the main power supply as follows:
-
INSTALLATION INSTRUCTIONS
SECTION 200-255-204
FEBRUARY 1992
6) Check the 15amp fuse (Fl) located at the top
of the power supply to verify that it is in working
order.
7) Remove plastic cover from AC connection
terminal TBl by removing two screws.
8) Connect the white and black leads to the AC
terminal (black to L and white to N) and the
green lead (ground) to the GND screw on the
main power supply (Figure 4-2). Replace the
plastic cover and secure with two screws.
1) Remove the two screws securing the basic
cabinet front cover. Lift the cover off the cabinet.
2) Loosen two screws, remove and retain four
screws securing the basic cabinet rear cover
plate, and remove the rear cover plate (Figure
4-l).
Ir
0
\
/f
LOOSEN
2 SCREWS
-
REMOVE
4 SCREWS -)(
FIGURE 4-l-PERCEPTION@
BASIC CABINET REAR COVER
3) Unpack the main power supply and inspect it
carefully for any visible damage. Verify that all
connectors are securely attached.
4) Remove and retain the three corner screws
from the back of the main power supply.
5) Slide the main power supply into the basic
cabinet from the front and secure in place with
three screws at the rear.
5515 - J509
i-
GROUND STRAP
FIGURE 4sP-PERCEPTION,
CABLE CONNECTIONS
4-1
Advertisement
Chapters
Table of Contents
