Print Dialed Number Service Data Block (Table 9-8) - Toshiba Perfecptione Installation And Maintenance Manual

PROGRAMMING PROCEDURES
SECTION 200-255-309
FEBRUARY 1992
TABLE 9-7 (continued)
Error Codes
I
Program Name: Dialed Number Identification Service Data Block (DDNI)
I
1 Error Code 1 Meaning
I
ERDNI 00
ERDNI 01
The data is already assigned (REQ=NEW).
The number of "DIG" is different from "NUM."
I
ERDNI 02
I
Input DIG data has already been assigned.
I
ERDNI 03
ERDNI 04
ERDNI 05
Input DN or table is not assigned.
The input data was erased because the program was aborted during a NEW data entry.
There is an inappropriate character.
ERDNI 06 Input DN cannot be assigned for the destination DN.
I
2. When TEN = Y, the programming of TEN
= 0 or 1 in the DTGP Program
controls
which console calls route to. Tenant ser-
vice does not load share.
DIS (Alphanumeric Display)--Defines the al-
phanumeric characters to be displayed.
Enter: Maximum of 16 characters.
or
None (LCD display will show trunk #I.)
8. Print Dialed Number Identification Service
Data Block (Table 9-8)
8.01 To use the Print Dialed Number Identification
Service Data Block (PDNI Program):
l
Perform the Authorization Procedure (Level 1 or
2).
Enter: PDNI (in response to the OK prompt).
l
When the REQ prompt is received after the
program is loaded:
Enter one of the following commands:
TBL ALL-All DNIS Data Blocks will be out-
::.-r-,
put.
'. "
NUM X-All X (X = 1 - 5) Digit Data Blocks
will be output.
TABLE 9-8
Procedure - Print Dialed Number Identification Service Data Block
Authorization Procedure must be completed. If an OK response is received, proceed as follows:
I
ITEM PROMPT
USER ENTRY
NOTE
I
OK
1 PDNI I I
- DISK LOADING -
=Q
TBL ALL, NUM X 1
NOTE:
The following responses are possible:
Tl3L ALL = All DNIS Data Blocks will be output.
NUM X = All X (X = 1 - 5) Digit Data Blocks will be output.
9-20