Toshiba Perfecptione Installation And Maintenance Manual page 198

PROGRAMMING PROCEDURES
SECTION 200-255-309
FEBRUARY 1992
6. Print Station Message Detail Recording Data
Block (Table 9-6)
6.01 To use the Print SMDR Data Block (PMDR
Program):
l
Perform the Authorization Procedure (Level 1,2,
or 3):
Enter: PMDR (in response to the OK prompt).
l
When an REQ response is received after the
program is loaded:
Enter: PRT.
l
The SMDR Data Block will be printed out in the
following format:
REQ PRT
ACL
xx (01 12)
SPCCl NXXXXXX or 1 OXXX
SPCC2 NXXXXXX or 1 OXXX
TGP xx xxx
TGP xx xxx
etc.
l
The REQ prompt will be given when the printout
is complete.
Enter: mm
q
(to exit the program).
7. Dialed Number Identification Service Data
Block (Table 9-7)
7.01 The Dialed Number Identification Service
(DNIS) Data Block (DDNI Program) is used to
program DNIS numbers, destinations, and alpha-
numeric displays. The system refers to this data
block for routing and other handling instructions for
TABLE 9-6
Procedure - Print Station Message Detail Recording (SMDR)
Authorization Procedure must be completed. If an OK response is received, proceed as follows:
I
ITEM PROMPT USER ENTRY NOTE
OK PMDR
- DISK LOADING -
I
=Q
1
I
- EXECUTE -
I
REQ 1
NOTES:
1. The only response possible is: PRT = Outputs SMDR Data Block.
Ignore line entered.
Backspace.
Stop printing and return to REQ.
Exit program.
9-18