System Data; Authorization Code Change (Table 5-I) - Toshiba Perfecptione Installation And Maintenance Manual

CHAPTER 5
SYSTEM DATA
1. Authorization Code Change (Table 5-1)
1 .Ol The DCHG Program changes the authoriza-
tion codes which are used in the Authorization
Procedure.
2.
1.02 To use the DCHG Program:
Complete the Authorization Procedure (Level 1
or 2).
Enter:
Enter: DCHGm (in response to the OK prompt).
The next prompt will be: LiXXXX (Level 1 au-
thorization code).
(XXXX = present code.)
New L2 code (4 digits)
q
. j
L3XXXX (Level 3 authorization
code).
Enter:
(XXXX = present code.)
(XXXX = present code.)
New L3 code (4 digits)
q
,
L4XXXX (Level 4 authorization
code).
NOTES:
Enter: New L4 code (4 digits)
q
,
I. If a Level 2 authorization code was given
En ten m m (to exit the program).
PROGRAMMING PROCEDURES
SECTION 200-255-305
JANUARY 1993
above, L 1 willnotbe output. Go to the next
prompt (L2).
If a Level 3 authorization code was en-
tered above, an error message will be
given, Level 3 cannot change the authori-
zation codes.
Enter:
New L 1 code (4 digits) a.
L2XXXX (Level 2 authorization
code).
TABLE 5-l
Procedure - Authorization Code Change
Authorization Procedure must be completed. If an OK response is received, proceed as follows:
NOTES:
1.
2.
a. An error message will be received if Level3 or Level4 was given in the Authorization Procedure.
6. If Level2 was given in the Authorization Procedure, L 1 will be omitted and the response to CHG
will be: L2 = XXXX.
c. XXXX = Present code of the designated level 1 - 4.
The possible responses are:
YYYY =
(9
This new access code will replace the existing XXXX.
= Carriage Return - the code will not be changed and the system will issue the next
prompt.
= Ignore line entered.
= Backspace.
- Stop printing and return to REQ.
= Exit program.
3. Enter: Y or N.
5-I