Toshiba Perfecptione Installation And Maintenance Manual page 175

PROGRAMMING PROCEDURES
SECTION 200-255-307
JANUARY 1993
TABLE 7-8 (continued)
Error Codes
Program Name: DSS Console Data Block (DDSS)
Error Code Meaning
ERDSS 00
A PCB is not equipped in that location.
ERDSS 01
The port has already been assigned (REQ = NEW).
ERDSS 02
The wrong button number was entered.
ERDSS 03
The input DSS console or feature button conflicts with the existing button.
I I
ERDSS 04
The PCB is not an NDSU/NDKU.
ERDSS 05
The port is not assigned (REQ = CHG, OUT).
ERDSS 06
The port is busy (REQ = CHG, OUT).
1
ERDSS 07 1 An electronic/digital telephone has already been assigned to the PCB.
ERDSS08
1 Two DSS have already been assigned to the electronic/digital telephone.
I
ERDSS 09
The start button number is larger than the end button number (DUP).
ERDSS 10'
Them button or feature button conflicts with an existing button (DUP).
ERDSS 11
The m button has already been assigned in this tenant.
ERDSS 12
The input port cannot be disabled.
ERDSS 13
The wrong button parameter was entered.
ERDSS 14
The input port is not an electronic/digital telephone port (SIG LNNX).
I I
ERDSS 15
ERDSS 16
ERDSS 17
A station port (SPT) was entered, but the DSS console has already been assigned to the PCB.
The start button number is larger than the end button number (AUT).
The button data does not exist.
I
ERDSS 18 1 The type of button assignment (Fixed/Switched) is different from the master DSS console.
1
ERDSS 19 m button is set, but station is not set (DIS = 1).
ERDSS 20
m button is set, but station is not set (DIS = 2).
ERDSS 21 The
port
must be assianed to a COO or CO1 location.
ERDSS 22
ERDSS 23
ERDSS 24
ERDSS 25
ERDSS 26
ERDSS 27
ERDSS 28
ERDSS 31
The input DN is a trunk DN (VCP NNN).
This SDC has already been assigned.
A m button has been entered, but a Call Pickup Group has not been assigned.
The maximum number of m buttons (500) has already been assigned.
Too many digits have been assigned to ADL (maximum = 16).
Fixed dialing digits cannot be assigned to m buttons. Assign these digits to m buttons.
The m button is set, but the station is not an attendant-position electronic/digital telephone.
The port has already been assigned to OCA.
7-28