Toshiba Perfecptione Installation And Maintenance Manual page 205

PROGRAMMINGPROCEDURES
SECTION 200-255-310
FEBRUARY1992
3. Codes cannot be added and deletedin the
same pass through the table. A separate
pass is required for each step.
4. Following the OCDprompt, an 'A"prompt
will appear and any entered codes will be
added. To delete, press the return key
m. A 'D" will appear and any entered
codes will be deleted.
RANGES EXAMPLE:
4-digit Format Off ice Codes
2209 220 - 229
2316 231 - 236
2478 247 - 248
Restriction Class Table
TABLE10-3
Load the DTOL Utility Program. When the TYPE prompt is received, proceed as follows:
Area Code List = Add or Delete
Office Code List = Add or Delete
Default values are noted in parentheses ( ).
NOTES:
1. Enter the number of the Toll Restriction class (0 - 7) that is being defined.
This number will be used
in the DEKT, DSlT, and DTGP Data Blocks in response to the TOL prompt.
2. Enter OUT after the class number (NOUT) to remove that class from service.
3. Defines the Area Code Table of this class as an allow (A) or deny (0) type.
a. IfA is entered, thesystem willallowallarea codes except those deletedin response to the ACD
prompt (Note 4).
b. If D is entered, the system will deny all area codes except those added in response to the ACD
prompt (Note 4).
4. Used to add or to delete area codes from the table (Note 3).
5. Defines the Area Code Table of this class as an allow (A) or deny (0) type.
a. If A is entered, the system will allow all office codes except those deleted in response to the
OCD prompt (Note 6).
b. If D is entered, the system will deny all office codes except those added in response to the OCD
prompt (Note 6).
6. Used to add or delete office codes from the table (Note 5). Ranges are possible (7309 = 730 - 739).
= Ignore line entered.
= Backspace.
= Stop printing and return to REQ.
= Exit program.
10-5