Toshiba Perfecptione Installation And Maintenance Manual page 162

TABLE 7-3
Procedure - Standard Telephone Data Block
PROGRAMMINGPROCEDURES
SECTION 200-255-307
JANUARY1993
Authorization Procedure must be completed. If an
OK
response is received, proceed as follows:
ITEM
PROMPT
USER ENTRY NOTE
OK
DS-IT
JY-IAl,
Port Number
- DISK LOADING -
-Q
NEW, CHG, OUT
POR
LNNX l&2
Directory Number
I
DN
1 - 4 digits
I 3 I
Station Mix
SMX
Y or N
Class of Service
cos o- 15
4
Tenant Number
TEN
0 or 1
5
Call Pickup Group
PUG
0 - 31 or NONE
6
Hunt number
Dialing Type
Speed Dial List
HNT 1 - 4 digits, #X, or NONE
7
DLG DIP, TON, MNL XXXX
8
SDL SDC XX, SDU XX, or NONE 9
Warning Tone Allowed?
Call Forward to Trunk
WTA
CFT
Y or N
Y or N
10
Toll Restriction Class
Message Waiting Lamp
Emergency Ringdown Station
Off-hook Call Announce
TOL
MWL
RDS
OCA
0-8orNONE
Y or N
1 - 4 digits, ATT, UNA, or NONE
AorM
11
I
-JQ
Repeat program, if necessary
I
I
NOTES:
(continued)
1. NN = PCB location.-
2. X = Circuit number.
3. 4-, 3-, 2-, or l-digit DNs are allowed if there is no conflict (e.g., 30X is not allowed if 30 is used).
4. There are 16 different COS groups which are defined in the DCOS Data Block.
5. When RNA calls recall to the Attendant, they will recall to the Attendant (0 or 1) that ORIGINALLY
transferred the call.
6. There
is a
maximum of 32 Call Pickup Groups.
7. The number to which this DN hunts.
#X = Station Hunt-Distributed,
X = Distributed hunt group number
(0 - 3), Maximum 8 members per group.
NONE = No hunt.
8. DIP = Dial Pulse. TON = DTMF. MNL XXXX = Manual Line Direct to DN (1 - 4 digits), ATT 0, or
A777.
9. SDC XX makes the station a controller of Station Speed Dial List XX (XX = 01 - 50).
SDU XX makes the station a user of Station Speed Dial List XX (XX = 01 - 50).
10. Y = Warning tones applied (call waiting feature activated).
N = No warning tones applied (camp-on feature activated).
7-15
.
I