Table of Contents
Advertisement
PROGRAMMINGPROCEDURES
SECTION 200-255-310
FEBRUARY1992
When entering CLS in response to TYPE (Table
NO/i X NO/i X etc. (in response
to the D
lo-3), the next prompt will be:
prompt)
to delete area codes.
CNO
(Class
Number)---Indicates
the number
of
the Toll Restriction
class that is being defined.
This number
is used in response
to the TOL
prompt
in the
DEKT, DSIT,
and
DTGP Pro-
grams .
Enter: 0 - 7 (Class Number)
or NOUT.
NOTE:
Enter OUT after the class number
(N) in order
to remove
that class from service.
OPR (Operator and Operator-Assisted Calls)-
A "Y" response
allows a station in this toll restric-
tion class to make
operator
and operator-as-
sisted calls.
Enter: Y or N.
INT (International Calls)-A
'Y" response
allows
a station
in this toll restriction
class to make
international
calls (011, 01).
Enter: Y or N.
LDA (Long Distance Directory Assistance)-A
'Y" response
allows a station in this toll restric-
tion class to call long distance
directory
assis-
tance.
Any area code
+ 555 + XXXX will be
allowed.
Enter: Y or N.
ACT (Area Code Table
Type)-Defines
the Area
Code Table of this toll restriction
class as either
an Allow (A) or a Deny (D) type table.
l
An "A" entry will allow all area codes except
those deleted
below, in response
to the ACD
prompt.
l
A "D" entry will deny all area codes except
those added
below, in response
to the ACD
prompt.
Enter: A or D.
ACD (Area Code
Table)-Indicates
the area codes
that are to be allowed
or denied
for this toll
restriction class. Area codes may be either added
or deleted,
as described
above.
Enter: NO/l X NO/i X etc. (in response
to the A
prompt)
to add area codes.
. . . or. . .
NOTES:
1. N=2
-9,
O/l=Oorl,
X=0
-9.
2. If "D" is entered
in response
to the ACT
prompt,
then "D" must also be entered
in
response
to ACD (and vice versa). For no
entries, press the return key m.
3. Following
the ACDprompt,
an 'A"prompt
will appear and any entered
codes will be
added.
To delete,
press
the return
key
m.
A "D" will appear
and any entered
codes will be deleted.
OCT (Office Code Table
Type)--Defines
the Of-
fice Code Table
of this toll restriction
class as
either an Allow (A) or a Deny (D) type table. An
"A" entry will allow all office codes within the
Home Area Code (HAC), except
those deleted
in response
to the OCD prompt.
A "D" entry will
deny all off ice codes within the Home Area Code,
except
those
added
in response
to the OCD
prompt.
Enter: A or D.
,'_
OCD
(Office Code
Table)-Indicates
the office
codes to be allowed or denied for this toll restric-
tion class. Office codes may be added or deleted
either as single 3-digit codes,
or as a "range"
covering up to ten sequential
3-digit office codes.
Ranges
are entered
by using a 4-digit format;
where the first two digits are common
to all codes
in this range; the third digit represents
the start-
ing point of the range (from) for the last digit of the
office code; and the fourth digit represents
the
end point of the range (to) for the last digit of the
office code. See ranges
example.
Enter: NXXX
NXX NXXX etc. (in response
to
the A prompt)
to add office codes.
. . . or. . .
NXXX
NXX NXXX etc. (in response
to
the D prompt)
to delete office codes.
NOTES:
1. N=2
-9,
X=0
-9.
2. If "D" is entered
in response
to the OCT
prompt,
then "D" must also be entered
in
response
to OCD (and vice versa). For no
entries, press the return key m.
10-4
Advertisement
Chapters
Table of Contents
