Toshiba Perfecptione Installation And Maintenance Manual page 242

PROGRAMMINGPROCEDURES
SECTION 200-255-315
FEBRUARY1992
TABLE15-1
Procedure - Traffic Measurement Data Block
Authorization Procedure must be completed. If in OK response is received, proceed as follows:
ITEM
I
PROMPT
- DISK
Schedule
I
ATT0
ATT1
TGPOO-TGP15
USER ENTRY
I NOTE
DTRF
I
,OADING - .+; s
SlT, RPT, OUT, CHG 1
MMDDYY or
q
(MMDDYY) .
.2
SUN, MON, TUE, WED, THU, FRI, SAT (DOW)
3
HHMMSS or
q
(HHMMSS)
4
Y or N (N)
I 8
Y or N (N) 8
Y or N (N) 8
Y or N (N)
8
Default values are noted in parentheses 0.
(continued)
NOTES:
1. SlT = Start Command- used to initialize the program and to start the record-keeping repotting activity.
RPT = Report Command- if the program had been startedpreviously, a repot? would follow. See Table
15 1 a for format. (The RPT command stops record-keeping reporting activity. The STT command
must be used to restart record-keeping reporting activity,)
OUT = Out Command - used to stop reports.
CHG = Change Command - used to alter reporting parameters.
2. The system will output the date in its memory (Month, Day, Year). Any entry (MMDDYY) will
overwrite the existing data. A
q
= no change.
3. Enter the day of the week: SUN, MON, TUE, WED, THU, FRI, or SAT. A
q
= no change.
4.
The
system will output the time in its memory (Hour, Minute, Second). An entry (HHMMSS) will overwrite
the existing data. A
q
= no change.
5. Schedule of Reports:
30 = Report every 30 minutes beginning at the time listed as STR. DATE (Note 6) and STR. TIME (Note 7).
60 = Repot? every 60 minutes beginning at the time listed as STR.DATE (Note 6) and STR. TIME (Note7).
6. Date that record-keeping and reporting should start. The system will output the date in its memory (Month,
Day, Year). An entry (MMDDYY) will overwrite the existing data. A
q
= no change.
7. The time that record-keeping and reporting should start. The system will output the time in its memory (Hour
and Minute). An entry (HHMM) will overwrite the existing data. A
q
= no change.
8. Enter Y or N, followed by a
q
to select the parameters to be reported (see Tab/e 15-lb).
= Ignore line entered.
= Backspace.
= Stop printing and return to REQ.
= Exit program.
15-2