Basic Display Selection - Honeywell DCP551 Mark ΙΙ User Manual

Chapter 6. OPERATION

6-2 Basic Display Selection

The console basic display status is comprised of the program number display, segment number display, display panel
1, display panel 2, basic display LEDs and the message panel.
Use the DISP key or MESSAGE key to cycle through the different displays. The mode display LEDs perform the
same functions both in the basic display status and during parameter settings and do not change by pressing the
DISP or MESSAGE key.
The displays and their functions are shown in the figure below.
Basic display LEDs
The LEDs go on when respective
function is operating.
Display panel 1
PV
DEV
OUT
CYC
SP
Display
TM
panel 2
SYN
Detailed descriptions follow.
6-2
PV
SP
(1)Falling temperature lamp
Current
(2)SOAK
segment
(3)Rising temperature lamp
Program and segment number display
Displays the program and segment number of
the selected program in the READY program run mode.
Displays the program and segment number of the
program and segment number of the currently running
program in modes other than READY mode.
Both displays are off in the fixed command control mode.
PROG SEG
Program Segment
number
number
PROFILE
Pattern trend
Profile display
Indicates when a program has been set in
program run mode. The display is off when no
setting has been made.
When a setting has been made, but there is
no next segment the three LEDs on the right
are off.
This display is off in the fixed command control
mode.
PROFILE
(4)Rising temperature lamp
Next
(5)SOAK
segment
(6)Falling temperature lamp