Load Procedures; Load Menu - Honeywell DCP551 Mark ΙΙ User Manual

Chapter 9. MEMORY CARD OPERATIONS

9-3 Load Procedures

Insert a memory card when the DCP551 is in the READY mode and the normal display mode, and variable parame-
PA05
ter has been set to 0. Press the LOAD key to start a load operation. "
LOAd
" " is displayed in display panel 2. An error code appears if something should go wrong during the save opera-
tion.

Load menu

Load individual programs
Load Card--->DCP
Program?
Load all programs
Load Card--->DCP
All Programs?
Load setup data
Load Card--->DCP
SETUP Data?
Load variable parameters
Load Card--->DCP
PARA Data?
Load PID parameters
Load Card--->DCP
PID Data?
Load event configuration data
Load Card--->DCP
EVENT Data?
Load all parameters
Load Card--->DCP
All Parameters?
9-6
When the LOAD key is pressed in the normal display mode, the load menu panel is dis-
played. Use the ENTER key to select the desired menu.
Press the ENTER key to display the desired menu in the message display panel. The
DISP key returns you to the normal display mode.
Note, however, that an autoload operation is performed when the LOAD key is pressed
PA05
and variable parameter
For details, see "Section 9-4 Autoload" (page 9-10).
A RAM memory card whose internal batteries are too low, cause a card battery alarm
panel to be displayed before the Load menu panel is displayed.
Normal display mode
LOAD key
¯
key
­
key
¯
key
­
key
¯
key
­
key
¯
key
­
key
¯
key
­
key
¯
key
­
key
¯
key
­
key
¯
key
­
key
CArd
is set to 1.
DISP key
ENTER key
Procedures for loading single programs (page 9-7)
ENTER key
Procedures for loading all programs (page 9-8)
ENTER key
Procedures for loading setup data (page 9-8)
ENTER key
Procedures for loading variable parameters (page 9-8)
ENTER key
Procedures for loading PID parameters (page 9-8)
(including fixed command control data)
ENTER key
Procedures for loading event configuration data (page 9-9)
ENTER key
Procedures for loading all parameters (page 9-9)
" is displayed in display panel 1 and