Parameter Setting Related Problems; Program Setting Related Problems - Honeywell DCP551 Mark ΙΙ User Manual

Chapter 10. TROUBLESHOOTING
General reset cannot be performed with FUNC, CLR and MESSAGE keys
Cause
Normal display mode not on
Mode other than READY mode
Set to MANUAL mode.
Set to memory protect.
Set to key lock.

Parameter setting related problems

Registration state cannot be invoked with ENTER key
Cause
Ò-----Ó displayed in display panel 2
Data displayed in display panel 2 cannot be changed.
Set to memory protect.

Program setting related problems

Registration state cannot be invoked with ENTER key
Cause
Set to memory protect.
Item changes cannot be made with ↑ and ↓ keys
Cause
Not pattern item set.
SP values in program settings cannot be changed with ↑ and ↓ keys
Cause
SP limit sets error value.
Event items cannot be displayed with ↑ and ↓ keys
Cause
Event type is something other than segment
type.
Programming item sets no display.
10-6
Press DISP key to invoke normal display mode.
Set READY mode to execute RESET operation (PROG +
RUN/HOLD keys).
Set AUTO mode to execute AUTO operation (A/M key).
Set variable parameter
PA02
Set variable parameter
PA01
This item cannot be displayed or set. To change setting
connection item, it may be able to change or set.
This item is display only.
PA02
Set variable parameter
Set variable parameter
PA02
Set SP and time data.
Set correct value for setup data
Set the event type in the event configuration data to a value
between 1 and 23.
Set setup data to 0.
C57
Measure
to 0.
to 0.
Measure
to 0.
Measure
to 0, 2 or 4.
Measure
Measure
and .
C66 C67
Measure