Honeywell DCP551 Mark ΙΙ User Manual page 56

• When there is a G.SOAK wait at the start of a segment and the ON Time is set to 0,
the output goes on at start of the G.SOAK wait and the On Time starts as the
G.SOAK wait ends.
The output time = G.SOAK time + (Off Time – On Time) (see segment 8.)
Segment
On-time
The output goes on at the start of
segment 8 when on is set to 0.
Off-time
Output-ON
Output-OFF
• An On Time and Off Time occurring at the end of a RAMP-X segment are valid when
there is a G.SOAK wait at the end of a segment or as the end state of the final segment.
(See segment 10 in the figure.)
Note, however, that an On Time or Off Time setting at the end of a RAMP-T segment
is either valid or invalid depending on the computational error.
Segment
On-time
Off-time
Output-ON
Output-OFF
Segment
Segment time
ON = Segment time
On-time
Off-time
Output-ON
Output-OFF
8
G.SOAK wait Start of segment 8
9
ON = Segment time
10
Chapter 5. FUNCTIONS
G.SOAK wait
5-7