Calibration Procedures; Enter Calibration Mode - Honeywell DCP551 Mark ΙΙ User Manual

12-2 Calibration Procedures

Enter calibration mode

(1) Release keylock. (PARA
(2) Press DISP key to permit ordinary indication condition.
Change to READY (RUN and HLD are off) and AUTO (MAN off) modes.
The following LEDs will illuminate after the above operations.
RUN LED is OFF
HLD LED is OFF
MAN LED is OFF
Upper Display
Lower Display
(3) To enter calibration mode, hold down the FUNC key, and press SETUP key and
ENTER key simultaneously.
The display will show the symbols described in Figure 12-3. If the indication is dif-
ferent, repeat the above procedure after pushing DISP key to refresh the display.
(4) To select individual calibration items, press ↑, ↓, ←, or → keys to select the item
by scrolling, then SETUP key, and ENTER key.
The order of calibration items is described in Table 12-2.
0.0.0.0.
A.d.J.S.
PA01=0
)
PROG Display
(Program No. Display)
PROG
PV
DEV
OUT
CYC
RUN
SP
HLD
TM
MAN
SYN
PRG
ADV
PROG RUN/HOLD DISP
RESET
MESSAGE
A/M PID PARA CLR
FUNC AT SETUP ENTER
LOAD
CARD
Figure 12-2.
00
PROG
PV
DEV
OUT
PROFILE
CYC
RUN
SP
HLD
TM
MAN
SYN
PRG
ADV
PROG RUN/HOLD DISP
RESET
MESSAGE
MESSAGE
A/M PID PARA CLR
FUNC AT SETUP ENTER
LOAD
LOADER
CARD
Figure 12-3.
Chapter 12. CALIBRATION
SEG Display
(Segment No. Display)
SEG
PROFILE
AT
BAT
EG1
EG2
MESSAGE
SAVE
LOADER
00
SEG
AT
BAT
EG1
EG2
SAVE
12-7