Copying Programs; Program Copy Procedures - Honeywell DCP551 Mark ΙΙ User Manual

8-2 Copying Programs

The DCP551 allows you to copy programs when it is in the READY program run mode. If not in this mode, press the
DISP key to invoke the normal display mode.

Program copy procedures

Display
(1) Invoke the program run READY program run mode.
Set variable parameter
(2) Press the PROG key and the ↑, ↓, ←, and → keys in the normal display mode to
select the number of the program to be copied.
This is not possible when the program number is selected using external switch
inputs.
See "Section 6-3 Selecting Programs" (page 6-7) for details.
(3) Press the ↑ key and the PROG key to display "
ber of the program to be copied starts to flash in display panel 2.
(4) Press the ↑ and ↓ keys and currently unset program numbers that can be used as
numbers for the program to be copied start to flash.
When there are no unset numbers, "-----" is displayed in display panel 2.
(5) Press the ENTER key to start program copy and display panel 2 stops flashing.
Repeat steps (4) and (5) to copy more programs.
(6) When a program has been copied, press the DISP key.
Copy destination
program number
PA01
to 0 or 1 and set variable parameter
COPY
PROG
Program
number
PROFILE
Pattern trend
Chapter 8. PROGRAM SETUP
PA02
to 0.
" in display panel 1. The num-
SEG
Segment
number
8-23