Setting Cycle Items - Honeywell DCP551 Mark ΙΙ User Manual

Setting cycle items

Display
NOTE
(1) In the set value display state, move to the cycle item to be set for the segment on the
programming map.
(A cycle item is a program setting and is the same for each segment.)
(2) Press the ENTER key to make display panel 2 flash (registration of first setting).
(3) Use the ↑, ↓, ←, and → keys to make the first setting – setting the cycle value.
Setting range: 0 to 10000
(4) Press the ENTER key to stop the flashing on display panel 2.
(Pressing the FUNC and CLR keys causes display panel 2 to return to unset state
0
" " and the flashing stops.)
Set cycle count value
P R O G R A M C Y C L E
• A cycle item is a program setting and is the same for each segment.
C60
• When setup data is set to 1, a cycle item on the programming map is skipped and
not displayed.
A cycle item setting does not use subfunctions.
Chapter 8. PROGRAM SETUP
PROG SEG
Program Segment
number number
PROFILE
Pattern trend
8-17