Honeywell DCP551 Mark ΙΙ User Manual page 129

No.
Item code
Voltage output control
95
C 95
Unused
96
C 96
Communications port
97
C 97
Special function
98
C 98
PV1 zener barrier adjustment
99
C 99
PV2 zener barrier adjustment
100
C100
Factory default
Item
settings
15
----
0
0
----
----
Chapter 7. PARAMETER SETUP
User
Settings and descriptions
settings
2 to 22mA
[Description:]
Ò-----Ó is displayed and setting cannot be performed.
0 to 15
The backplate terminal is used when set to 0.
The loader jack is used for settings 1 to 15.
[Description:]
When set to 0, communications cannot be performed on model without
communications.
When set to 0, communications conditions are selected using
The communication address is used for settings 1 to 15.
4800bps, 8 bits, even parity, 1 stop bit
0 to 255
[Description:]
A setting of 0 is normally used.
Ð20.00 to +20.00
[Description:]
Ò-----Ó is displayed and setting cannot be performed when
PV1 is not RTD or C98 is not equal to 241.
Ð20.00 to +20.00
[Description:]
Ò-----Ó is displayed and setting cannot be performed when
PV2 is not RTD or C98 is not equal to 241.
to .
C76 C80
7-27