Honeywell DCP551 Mark ΙΙ User Manual page 145

When the event is a code event
(1) In the set value display state, move to the event item to be set for the segment on the
(2) Press the ENTER key to make display panel 1 flash (registration of first setting).
(3) Use the ↑, ↓, ←, and → keys to make the first setting – setting the event output
(4) Press the ENTER key to stop the flashing on display panel 1.
Display (code event)
Unset values are indicated as "-----".
NOTE
Code events use one subfunction. A subfunction cannot be used when a setting has not
been made "-----".
Events that follow the event number of a code event (number of output points less 1) are
skipped and not displayed.
programming map.
code.
n
Setting range: 0 to 2 – 1
(n indicates the number of output points set in event configuration 1
auxiliary setting 1.)
(Pressing the FUNC and CLR keys causes display panel 1 to return to unset state
"-----" and the flashing stops.)
Output code setting
Event number
Event type and No. of outputs
Chapter 8. PROGRAM SETUP
PROG SEG
Program Segment
number number
PROFILE
Pattern trend
8-9