Detailed Information On Variable Parameters - Honeywell DCP551 Mark ΙΙ User Manual

Detailed information on variable parameters

PA01
(keylock)
PA02
(memory protect)
0: keylock disabled
1: display of setup data setting disabled
2: display of all settings disabled
3: display of all settings disabled. Operation keys disabled
• The following keys are disabled when
Normal display mode:
SETUP key
FUNC + CLR + MESSAGE keys
• The following keys are disabled when
Normal display mode:
SETUP key
FUNC + CLR + MESSAGE keys
FUNC + PARA keys
PID key
FUNC + PID keys
FUNC + PROG keys
↑ ↑ + PROG keys
LOAD key
SAVE key
• The following keys are disabled when
Normal display mode:
PROG key
RUN/HOLD key
PROG + RUN/HOLD keys
PROG + DISP keys
FUNC + → → keys
A/M key
AT key
Note, however, that in the normal display mode in MANUAL mode MV (controller)
and SP (programmer) can be changed.
0 : disabled
1 : program settings are protected
2 : setup, variable parameters and event configuration settings are protected
3 : setup, variable parameters, event configuration settings and program set-
tings are protected
4 : setup, variable parameters, event configuration settings and PID parameter
settings are protected
5 : program settings and all parameter settings are protected
PA02
• When is set to ≠ 0 (protect on), a general reset cannot be performed.
Chapter 7. PARAMETER SETUP
PA01
is set to 1.
(setup data setting)
(general reset)
PA01
is set to 2.
(setup data setting)
(general reset)
(event configuration data setting)
(PID parameter setting/constant value con-
trol data setting)
(constant value control data setting)
(program setting)
(program copy)
(memory card load)
(memory card save)
PA01
is set to 3 or to 2.
(program selection)
(RUN operation/HOLD operation)
(RESET operation)
(ADV operation)
(FAST operation)
(AUTO operation/MANUAL operation)
(AT start, AT cancel)
7-9