Honeywell DCP551 Mark ΙΙ User Manual page 23

Classification
Basic display Changes the display contents.
status
Changes the display contents on the message display.
Changes set program numbers in ascending order.
(In READY mode)
Performs RUN operation.
(In READY, HOLD, FAST, or READY FAST mode)
Performs HOLD operation.
(In RUN mode)
Performs RESET operation.
(In RUN, HOLD, FAST, END, or READY FAST mode)
Performs ADV operation.
(In RUN, HOLD, FAST, or READY FAST mode)
Performs FAST operation.
(In RUN, HOLD, or READY mode)
Performs MANUAL operation.
(In AUTO mode)
Performs AUTO operation.
(In MANUAL mode)
Starts auto tuning.
(When auto tuning is not in operation.)
Interrupts auto tuning
(When auto tuning is in operation.)
Changes numerics during MANUAL operation.
(When the MV or SV display flickers.)
Changes program numbers or segment numbers.
(When the program number or segment number flickers.)
Starts the variable parameter setting. (In basic display status)
Parameter setting
Starts the event configuration setting. (In basic display status)
Starts the PID parameter setting. (In basic display status)
Starts the setup setting. (In basic display status)
Starts the constant value control setting. (In basic display status)
Shifts each item.
Enters set values.
Completes a change in a set value. (When a set value flickers.)
Changes each item's set point. (When a set value flickers.)
Stops each item's set point. (When a set value flickers.)
Ends parameter setting.
Program setting Starts the program setting (programming). (In basic display status)
Shifts to program item or segment number.
Enters set values.
Completes a change in a set values. (When a set value flickers.)
Changes each item's set point. (When a set value flickers.)
Chapter 2. NAMES AND FUNCTIONS OF PARTS
Function Key operation
DISP
MESSAGE
PROG
RUN/HOLD
PROG + RUN/HOLD
PROG + DISP
FUNC +
A/M
AT
PARA
FUNC + PARA
PID
SETUP
FUNC + PID
ENTER
PARA
DISP
FUNC + PROG
ENTER
2-5