Mode Transitions - Honeywell DCP551 Mark ΙΙ User Manual

Chapter 5. FUNCTIONS

Mode transitions

Program operation
END AUTO
END MANUAL
Constant value control
Switching between program operation and constant value control
5-26
Mode transitions are indicated by the solid line arrows and end operation is indicated by
the dashed lines in the figure below.
READY AUTO
RESET
READY MANUAL
RESET
FAST
READY FAST AUTO
READY FAST MANUAL
NOTE
• AUTO ⇔ MANUAL mode changes can be made in the boxes of each mode.
• READY and END at the end of operation can be selected using setup data
Mode transitions are indicated by the solid line arrows.
RUN
READY AUTO
RESET
READY MANUAL
NOTE
AUTO ⇔ MANUAL mode changes can be made in the boxes of each mode.
Constant value control data "
switch between these two modes.
0: Program operation
1: Constant value control
NOTE
Constant value control is available only when setup data setting
C21
than 0. When is set to 0,
ADV
RESET
RUN
RUN AUTO
RESET
RUN MANUAL
FAST
RUN
RUN
RESET
ADV
RUN AUTO
RUN MANUAL
ConSt
" control mode item in the READY mode is used to
ConSt
is also set to 0.
ADV
HOLD
HOLD AUTO
RUN
HOLD MANUAL
FAST
HOLD
FAST AUTO
FAST MANUAL
ADV
C21
is set to more
ADV
C31
.