Starting the USM 36
3 Initial start-up
3.5 Starting the USM 36
Powering On
To start the USM 36, press the power On/Off key (1)
briefly.
The software is initialized. After that, the start display
showing the name of the instrument and information on
the software, serial number, and the installed options
will appear.
The instrument carries out a self-check and then switch-
es over to stand-by mode.
The settings of all function values and the default set-
tings (language and units) are the same as before pow-
ering the instrument off.
Powering Off
To power off the USM 36, press the power On/Off
1
key for 3 seconds.
The settings of all function values and the default set-
tings (language and units) are retained after powering
off.
USM 36
Issue 2 (12/2013)
3-11