Honda Accord 2008 Manual page 1502

07/11/02 09:35:39 61TA0000_190_0081
DTC 26-22: Acceleration Sensor Stuck
1. Turn the ignition switch to ON (II).
2. Clear the DTC with the HDS.
3. Do the VSA sensor neutral position memorization
(see page 19-138).
4. Test-drive the vehicle. Drive the vehicle at 7 mph
(10 km/h) or more.
NOTE: Drive the vehicle on a straight section of
road, not on a lift.
5. Check for DTCs with the HDS.
Is DT C 26-22 indicated?
YES − Go to step 6.
−
NO If any other DTCs are indicated, go to the
indicated DTCs troubleshooting. If DTCs are not
indicated, intermittent failure, the system is OK at
this time.
6. Check the LATERAL ACCELERATION SENSOR and
YAW RATE S in the VSA DATA LIST with the HDS.
Is 0 °/ s indicated?
YES − Go to step 7.
−
NO Replace the yaw rate-lateral acceleration
sensor (see page 19-138).
7. Test-drive the vehicle. Check the YAW RATE S in
the VSA DATA LIST with the HDS while driving in
corners.
Does the indicated value change?
YES − Intermittent failure, the system is OK at this
time.
−
NO Replace the yaw rate-lateral acceleration
sensor (see page 19-138).
ＴＡ０８ＡＥ４Ｋ８０１０００Ｒ２６２２ＦＡＡＴ００
19-81