Brake Hose Replacement - Honda Accord 2008 Manual

07/11/02 09:32:48 61TA0000_190_0039

Brake Hose Replacement

NOTE:
• Before reassembling, check that all parts are free of
dirt and other foreign particles.
• Replace parts with new ones whenever specified to
do so.
• Do not spill brake fluid on the vehicle; it may damage
the paint; if brake fluid gets on the paint, wash it off
immediately with water.
• To prevent the brake fluid from flowing, plug and
cover the hose ends and joints with a shop towel or
equivalent material.
Front
1. Remove the front wheel.
2. Disconnect the brake line (A) from the brake hose
(B), then remove the brake hose clip (C).
＊０１
C
Replace.
3. Remove the banjo bolt (A), and disconnect the
brake hose (B) from the caliper.
＊０２
B
C
8 x 1.25 mm
4. Remove the brake hose mounting bolt (C), then
remove the brake hose.
A
B
A
5. Install the brake hose (A) with the mounting bolt (B).
A
B
8 x 1.25 mm
22 N·m
(2.2 kgf·m,
16 lbf·ft)
C
10 x 1.0 mm
35 N·m
(3.6 kgf·m,
26 lbf·ft)
D
Replace.
6. Connect the brake hose to the caliper with the
banjo bolt (C) and new sealing washers (D).
7. Install a new brake hose clip (A) to the brake hose
(B) on the bracket, then connect the brake line (C).
Do not twist the brake hose.
C
A 10 x 1.0 mm
Replace. 15 N·m (1.5 kgf·m, 11 lbf·ft)
8. After installing the brake hose, bleed the brake
system (see page 19-9).
9. Do the following checks:
• Check the brake hose and line joint for leaks, and
tighten if necessary.
• Check the brake hoses for interference and
twisting.
10. Clean the mating surfaces of the brake disc and the
inside of the wheel, then install the front wheel.
ＴＡ０８Ａ００Ｄ１４３０００１４７５１ＫＢＡＴ００
B
(cont'd)
19-39
＊０３
＊０４