Honda Accord 2008 Manual page 1534

07/11/02 09:36:26 61TA0000_190_0113
5. Turn the ignition switch to LOCK (0).
6. Short the SCS line with the HDS.
7. Disconnect ECM/PCM connector A (49P).
8. Turn the ignition switch to ON (II).
9. Measure the voltage between brake pedal position
switch 4P connector terminal No. 2 and body
ground.
＊０１
BRAKE PEDAL POSITION SWITCH 4P CONNECTOR
Is there 0.1 V or more?
YES
the ECM/PCM and the brake pedal position
switch.
−
NO
latest software (see page 11-231), or substitute a
known-good ECM/PCM (see page 11-7), then go to
step 1 and recheck. If the ECM/PCM was updated
and DTCs are not indicated, troubleshooting is
complete. If the ECM/PCM was substituted and
DTCs are not indicated, replace the original ECM/
PCM (see page 11-232).
LT GRN
Wire side of female terminals
− Repair short to power in the wire between
Update the ECM/PCM if it does not have the
10. Update the VSA modulator-control unit if it does
not have the latest software (see page 19-140). If
the unit already has the latest software, substitute a
known-good VSA modulator-control unit (see page
19-141).
11. Turn the ignition switch to LOCK (0), then turn it to
ON (II) again.
12. Check for DTCs with the HDS.
Is DT C 68-22 indicated?
YES − Check for loose terminals in the VSA
modulator-control unit 36P connector. If the VSA
modulator-control unit was updated, substitute a
known-good VSA modulator-control unit (see page
19-141), then retest. If the VSA modulator-control
unit was substituted, go to step 1.
−
NO If the VSA modulator-control unit was
updated, troubleshooting is complete. If the VSA
modulator-control unit was substituted, replace the
original VSA modulator-control unit (see page
19-141). If any other DTCs are indicated, go to the
indicated DTCs troubleshooting.
19-113