07/11/02 09:19:43 61TA0000_170_0029
Power Steering
Steering Column Removal and Installation
SRS components are located in this area. Review the
SRS component locations: 4-door (see page 24-19),
2-door (see page 24-21) and the precautions and
procedures (see page 24-23) before doing repairs or
service.
Removal
1. Adjust the steering column to full tilt down position,
and to the full telescopic out position.
2. Do the battery terminal disconnection procedure
(see page 22-89).
3. Remove the driver's airbag and the steering wheel
(see page 17-24).
4. Remove the column covers (see page 20-167).
5. Remove the steering joint cover (A).
*01
17-28
6. Loosen the upper steering joint bolt (A), and
remove the lower steering joint bolt (B). Disconnect
the steering joint (C) by moving the steering joint
toward the column. Do not disconnect the steering
joint from the column shaft (D).
NOTE:
• If the center guide (E) is in place and has not
moved, leave it in place.
• If the center guide has moved or been removed,
discard it.
D
C
A
E
TA08A00F00000057101KDAT00
A
8 x 1.25 mm
B
8 x 1.25 mm
*02