Front Brake Disc Inspection - Honda Accord 2008 Manual

07/11/02 09:31:48 61TA0000_190_0020
Conventional Brake Components

Front Brake Disc Inspection

Runout
1. Raise the front of the vehicle, and support it with
safety stands in the proper locations (see page 1-9).
2. Remove the front wheels.
3. Remove the brake pads: NISSIN type (see page
19-13), AKEBONO type (see page 19-17).
4. Inspect the brake disc surface for damage and
cracks. Clean the brake disc thoroughly, and
remove all rust.
5. Install suitable flat washers (A) and the wheel nuts
(B), and tighten the wheel nuts to the specified
torque to hold the brake disc securely against the
hub.
＊０１
6. Set up the dial gauge against the brake disc as
shown, and measure the runout at 10 mm (3/8 in.)
from the outer edge of the brake disc.
Brake disc runout:
Service limit: 0.04 mm (0.0016 in.)
19-20
10 mm
A
(3/8 in.)
B
12 x 1.5 mm
108 N·m (11.0 kgf·m, 79.6 lbf·ft)
7. If the brake disc is beyond the service limit, refinish
the brake disc with a commercially available on-car
brake lathe.
Max. refinishing limit:
NISSIN type: 26.0 mm (1.02 in.)
AKEBONO type: 21.0 mm (0.83 in.)
NOTE:
• If the brake disc is beyond the service limit for
refinishing, replace it (see page 19-22).
• A new brake disc should be refinished if its
runout is greater than 0.04 mm (0.0016 in.).
8. Clean the mating surfaces of the brake disc and the
inside of the wheel, then install the front wheels.
ＴＡ０８Ａ００Ｄ１４３０００１４７２１ＭＡＡＴ１０