Lower Arm A Replacement; Control Arm Replacement - Honda Accord 2008 Manual

07/11/02 09:28:42 61TA0000_180_0045

Lower Arm A Replacement

1. Raise the rear of the vehicle, and support it with
safety stands in the proper locations (see page 1-9).
2. Remove the rear wheel.
3. Remove the parking brake cable mounting bolt (B).
＊０１
B
8 x 1.25 mm
22 N·m
(2.2 kgf·m,
16 lbf·ft)
4. Remove the lower arm A mounting bolts, then
remove lower arm A.
NOTE: Use new mounting bolts during reassembly.
5. Install lower arm A in the reverse order of removal,
and note these items:
• First install all the components, and lightly
tighten the bolts and nuts, then raise the
suspension to load it with the vehicle's weight
before fully tightening to the specified torque
values.
• Before installing the wheel, clean the mating
surfaces on the brake disc and the inside of the
wheel.
• Check the wheel alignment, and adjust it if
necessary (see page 18-5).
ＴＡ０８Ａ００Ｂ４４１０００３７７０１ＫＢＡＴ００
12 x 1.25 mm
59 N·m
(6.0 kgf·m, 43 lbf·ft)
Replace.
UPPER
A
12 x 1.25 mm
59 N·m
(6.0 kgf·m,
43 lbf·ft)
Replace.

Control Arm Replacement

1. Raise the rear of the vehicle, and support it with
safety stands in the proper locations (see page 1-9).
2. Remove the rear wheel.
3. Remove the control arm mounting self-locking nut
(A) and washer (B) from the knuckle side.
NOTE: Use a new self-locking nut during
reassembly.
C
Replace.
FRONT
D
E
F
12 x 1.25 mm
57 N·m
OUTSIDE
(5.8 kgf·m,
42 lbf·ft)
Replace.
4. Mark the cam positions of the adjusting bolt (C) and
the adjusting cam plate (D) with the frame.
5. Remove the self-locking nut (E) while holding the
adjusting bolt, then remove the adjusting cam plate,
adjusting bolt, and the control arm (F).
NOTE: Use a new adjusting bolt and a new self-
locking nut during reassembly.
ＴＡ０８Ａ００Ｂ４４１０００１７２５１ＫＢＡＴ００
A
12 x 1.25 mm
59 N·m
(6.0 kgf·m, 43 lbf·ft)
Replace.
B
(cont'd)
18-45 18-45
＊０１