Table of Contents
Advertisement
8. Push down on the hood latch. The access panel slides to a closed position.
9. Use the T-15 Torx screwdriver attached to the rear of the server to tighten the security screw on the
hood latch.
10. Install the server into the rack.
11. Reconnect the power cords and cables to the back panel of the server.
12. Press the Power On/Off button on the server, to turn on the server.
5.5.4
Verifying correct BIOS settings
All Honeywell systems must have the Honeywell recommended BIOS version. Honeywell configures
specific BIOS settings in the factory for each of the server platform configurations, and these settings
must not be altered. BIOS settings for the server are listed in the tables.
The following table provides the default BIOS settings for two FTE configuration and general ethernet
configurations.
BIOS setting
Broadcom Dual
Onboard NIC
5.5.5
BIOS settings for 51155539-100
This section lists the BIOS settings configured in the factory for the server with a RAID platform. Follow
the following steps to configure the settings:
1. Power-up the computer.
2. Press the F9 key to enter the BIOS setup utility. The BIOS version is P71 02/11/2014.
FTE only
Use Onboard NICs (NIC1
and NIC2)
- 50 -
Chapter 5 - Servicing
No FTE, but 1 or 2 ethernet ports
Use one or two Onboard NICs
(NIC1 or NIC2)
Advertisement
Table of Contents
