Adding Additional Memory; Prerequisites; To Add Additional Memory - Honeywell T320 Planning, Installation And Service Manual

Chapter 5 - Servicing
Configuration
through two on-board NICs
5.6

Adding additional memory

The standard memory capacity is 4 GB. The system memory can be increased to 8 GB, MZ-PCEM15.
Memory devices must be from the same memory supplier. For further information about the memory
configurations, refer to the section
5.6.1

Prerequisites

Turn off the system
l
Disconnecting power cords and cables from the server.
l
CAUTION
The DIMMs are hot to the touch for some time after the system is powered down. Allow time for
the DIMMs to cool before handling them. Handle the DIMMs by the edges and avoid touching
DIMM components.
5.6.2

To add additional memory

1. Remove the front bezel. Refer to the section
2. Remove the side cover of the server. Refer to the section
3. Hold the shroud and pull it up to remove it out from the chassis.
PCIE- PCIE- PCIE-
x 4 x 8 x 8
Slot Slot Slot
Memory configuration for Dell
Removing the front
- 56 -
PCIE-
x 4 PCIE-x 4
Slot PCSV71
PERC H310
l
Controller for MZ-
PCSV72
PERC H710
l
Controller for MZ-
PCSV73
T320.
bezel.
Removing the side cover.