Servicing The Hard Disk Drives And Power Supply; References - Honeywell T320 Planning, Installation And Service Manual

8. While wearing a grounded ESD wrist strap, grasp the LCNP4e/LCNP4e2 card at the corners and
gently remove the existing card from PCIe slot 3.
9. Insert the replacement LCNP4e/LCNP4e2 card firmly into PCIe slot 3, until the card is fully seated.
10. Align the LCNP4e/LCNP4e2 card edge with the card edge guide.
11. Replace the card retainers (blue plastic notch) to lock the inserted LCNP4e/LCNP4e2 board in
position.
12. Replace the side cover and front bezel.
5.4

Servicing the hard disk drives and power supply

The server from Honeywell is configured with five 146 GB or 300 GB SAS hard drives for RAID-5
configuration and the fifth hard drive is a hot spare. The configuration also contains redundant power
supplies. Both the hard disk drives and power supplies are hot swappable and must be of same
capacity and speed. You must replace only one power supply and/or hard disk drive at a time in a
system that is turned on. Refer to the Dell documentation for detailed instructions on swapping the
power supply and hard disk drive.
5.4.1

References

The following table lists the specific Dell publications and relevant sections for troubleshooting and
servicing the hard disk drives and power supplies.
- 53 -
Chapter 5 - Servicing