Detecting Slave Devices In The Network - Honeywell Experion PKS User Manual

6.11.5 Detecting slave devices in the network

You can detect all the physical slave devices in the network from the Field Network Configuration tab of the
Protocol Block. This can be accomplished by performing a Network Scan. This scan lists all the physical slave
devices connected to the network. In addition, you can add a slave device to the network, if the device is not
added to the network.
Perform the following steps to detect all slave devices in the network
Click the Field Network Configuration tab of the Protocol Block in which you have configured the master
1
and the slave device.
2 Right-click the master and select Network Scan.
Attention
If you have not assigned the device to the hardware, an message appears.
The netDevice window appears as displayed in the following figure. This window lists all the physical
devices that are present in the network and also the details of the devices.
6 PROTOCOL BLOCK
99