Honeywell Experion PKS User Manual page 65

Attention
• When you click Append, the last module you selected is placed at the end of the Configured Modules list.
• When you click Insert, you can place the new module between existing modules. You can use Insert to select
the slots of your choice for the I/O modules.
Select the Parameters menu from the Navigation Area.
6
7 Click Common from the Module list.
Attention
All the common parameters of the selected device appears in the Module list and you can configure the common
settings, as required. The parameters that appear in this list may vary based on the DSB selected.
Select the I/O module from the Module list.
8
9 Configure the channel type and the channel's high and low ranges. Refer to the following figure for an
example of configuring the analog module parameters.
Attention
• You must perform this step if you have selected the analog I/O modules.
Similarly, select the other I/O modules from the Module list and configure the channel type and the
10
channel's high and low ranges.
11 Select the DPV1 menu from the Navigation Area.
Attention
You can enable DP-V1 from the DPV1 menu in the Navigation Area. Note that PGM does not support DP-V1 in
R400. However, for the ET200M devices, DP-V1 is enabled by default.
Click Apply.
12
6 PROTOCOL BLOCK
65